Conan Exiles Enhanced Server Configuration

Most settings are exposed as form fields in the control panel and write to the standard Conan config files for you. Use this page as a reference for where to find each common setting.

Server name, password, max slots

1. Open your Conan Exiles Enhanced server in the control panel.
2. Click Modify Server Config.
3. Set Server Name, Server Password (leave blank for an open server), and your slot count.
4. Click Save and restart server.

Admin password

1. Open Modify Server Config.
2. Set the Admin Password field.
3. Click Save and restart server.

For logging in as admin in-game, see Adding Admins to a Conan Exiles Enhanced Server.

Gameplay multipliers

The most-tweaked options live in Modify Server Config:

• XP rate
• Harvest amount
• Item spoil rate
• Crafting time
• Stamina cost
• Day/night cycle speed

Default values match Funcom's defaults. Raise above 1.0 for an easier server, lower for harder.

PvP, PvE, and PvE-Conflict

Pick the mode in Modify Server Config under Game Mode:

• PvP — players can damage each other and structures any time.
• PvE — players cannot damage each other or each other's structures.
• PvE-Conflict — players can damage each other; structures take damage only during raid hours.

Raid hours (PvP and PvE-Conflict only)

Raid hours define when structure damage is allowed. Outside the window, buildings are invulnerable.

1. Open Modify Server Config.
2. Set Raid Hours Start and Raid Hours End (UTC, 0–23).
3. Optionally set a different window for weekends.
4. Click Save and restart server.

Map selection

Conan Exiles Enhanced uses a single merged world. The map dropdown shows Enhanced World (Merged Map) and that's the only option. Isle of Siptah is no longer a separate dedicated-server map.

Saving changes

The control panel offers three save modes:

• Save and restart server — applies immediately.
• Save without restart — writes the values; they apply on the next restart.
• Save form values only — stages values without writing the server's config files.

Most settings only take effect after a restart.